User's Manual

6
Chapter 2 Getting Started
 Inserting the battery
Open the battery cover and insert two AAA batteries.
Notes on batteries:
 Be sure that the polarity of the batteries is set properly.
 Do not charge, heat, open, or short-circuit the batteries.
 Do not leave dead or exhausted battery in the presenter.
 If you do not intend to use this unit for a long period of time, it is advisable
to remove the batteries.
 If the wireless presenter does not function correctly or if the operating
range becomes reduced, try to replace the battery with new ones.
 Do not use different type of batteries together, or mix old and new
batteries.
 Connecting the RF receiver
Connect the receiver to your notebook computer by plugging it into an available USB
port. If all your USB ports are occupied, you can also plug it into a connected USB hub.
Do as follows, depending on your operating system:
 Windows® 98 SE/Me
The system prompts you to insert the operating system CD-ROM. Follow the
instructions on the screen to install the required drivers.
 Windows® 2000/XP
The operating system identifies the receiver as a “USB Human Interface Device”
and begins installation automatically. Follow the instructions or messages on the
screen to complete the installation.
 Mac® OS
The receiver is automatically detected and enabled.