Bracket Guide

SB1 SINGLE PAN & TILT BRACKET ADAPTOR
Designed to mount any Raytec illuminator (normally 1 unit) to a Top Mount Pan/Tilt (PTZ) motor. The bracket should be fi tted
between camera housing and PTZ motor. Mounting holes provided to match with most industry standard PTZ units.
Several mounting options provided to mount Raytec illuminator.
Other versions available for specifi c PTZ motors.
Assembly Notes: Mount SB1 to PTZ unit. Mount illuminator to SB1 as shown below – bracket
can be mounted above or below SB1. Fix illuminator its bracket, as shown below. Set the
vertical/horizontal angle of illumination then tighten screws.
150.00
219.00
141.25
350.00
200.00
Ø8.00
350
219
109
105
36
Please be aware of the maximum width available to
mount camera to SB1.
Image shows an RM/RL 200 series illuminator
mounted on the outer most fi xing hole.
Please note: It is not possible to mount an RM/
RL 300 series illuminator on an SB1 bracket.
www.rayteccctv.com
7
UK Tel: [phone] Fax: [phone]
Americas Tel: [phone]