User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
Edition July 2015
2-121
4265.DOC020102
2.3.7.6 User Settings
The User Settings allow the operator to load Radar pre-adjustments. The pre-
adjustments are classified into three groups with special profiles. These profiles
contain Radar settings. The Radar settings become active when the Radar is
switched to TX mode.
Pre-Defined profiles provide display settings for navigation under special
conditions.
User Defined profiles are profiles containing the display setting used on each
workstation when Radar was switched to Standby the last time.
Workstation profiles are profiles containing console defined setting witch can
be transferred to another MFC console.
Group Pre-Defined
Group User Defined
Group Workstation
Default (see Table 2-10)
User_1
MFC1
Anchorage
User_2
MFC2
Harbor Berthing
User_3
…….
Pilotage
User_4
…….
Coastal Water
User_5
…….
Open Sea
In the Pre-Defined group the Default pre-adjustment contains following settings:
Table 2-10 Control settings in response to Default selection.
Parameter
Default collision avoidance
GAIN
As it is
Tuning
As it is
Range
6NM
Range rings
off