User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
4265.DOC020102
2-124
Edition July 2015
2.4 Select Target Information TGT INFO
The TGT INFO display can simultaneously show information on 3 tracked
targets. These can be ARPA, AIS or associated targets.
Manual selection is shown in the following procedure.
Automatic selection initiated by acquisition zones (chapter 2.5.1 ARPA targets,
chapter 2.5.4 AIS targets).
Operator controls
Task
changed to RCSE
and RSPD
AIS / ARPA Target association chapter 2.5.5.
ID Identifier no. ARPA (1..70), AIS ships identifier no.
STAT Status (TCPA, TI, TN, GUARD, REF) )*
TCSE True course can be changed to relative course
RCSE
TSPD True speed can be changed to relative speed
RSPD
DIST Distance
TBRG True bearing
CPA Closest point of approach
TCPA Time of closest point of approach
BCR Bow crossing range
BCT Bow crossing time
)* TCPA collision situation
TI Target initial, after approx. 10 scans
TN Target normal
GUARD Target acquired using an acquisition
zone
REF Info about a reference target