User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
4265.DOC020102
2-10
Edition July 2015
Operator controls
Text identifier
Editing marks
Drag and drop.
Pick up:
Position the cursor on the zone and press the right
trackball button. The zone is shown in a dotted form,
editing markers are shown at the corners. Position the
cursor on the desired marker. Press and hold the right
trackball button. Drag the marker to the desired position.
Drop:
Press once the right trackball button. The change is
completed; the zone switches from dotted to continuous
form.
2.1.4.2 Soft Buttons
This chapter describes the main soft button functions.
Displays the active heading sensor, the color indicates
the sensor quality.
RED for invalid, ORANGE for doubtful, BLACK for good
(corresponding to IEC 62288 edition 1) or ORANGE for
invalid, YELLOW for doubtful, BLACK for good
(corresponding to IEC 62288 edition 2).
The BLACK color depends on the color palette selection.
Pressing the soft button the function display shows the
available heading sensors.
Displays the actual CCRS selection mode, Sensor Mode
AUTO for automatic sensor selection, Sensor Mode
MAN for manual sensor selection.