User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
4265.DOC020102
2-20
Edition July 2015
2.2 Set to Operation
The set to operation process will be finished after about 8 minutes. Then the
Radar works completely and is ready to scan the sea area.
2.2.1 Switch ON
Operator controls
Text identifier
At the Radar Console.
The Power button is positioned on the front of the
Radar Console, lower left side. Press the Power
Button to turn on the Radar.
At the Remote Panel.
Press the Power Button to turn on the Radar.
The Utility Selection window appears on the display
(Figure 2-7). Select the RADAR soft button or the
MFC soft button by pressing the left trackball button
to start the Radar software.
Warm Up
After about 180 seconds, the message STANDBY
appears on the center of the display.
The system configuration diagram appears on the
center of the display area (Figure 2-6). The display is
automatically connected as slave display.
Select the requested transceiver/display combination
per cursor. Place the cursor at the M or S transceiver
symbol and press the left trackball button.
The STANDBY message changes to WARM UP.
After a 180 seconds (for X or S Band) the warm up
period is complete and the WARM UP message
changes back to STANDBY.