User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
Edition July 2015
2-25
4265.DOC020102
2.2.2 Switch OFF
The following procedure should be used to switch off the Radar system.
Table 2-6 Switch OFF
Operator controls
Text identifier
Switching the Radar OFF.
Use the trackball to place the cursor on the TX soft
button and press the left trackball button.
The designation of the soft button changes to STBY
and is highlighted.
When the Display was used in Master mode.
− Radar echo disappears.
− The antenna stops, no transmission.
− The name of the soft button FUNC changes
to SERV (Service).
− The soft button USER shows up.
− The soft button EXIT RADAR shows up.
When the display was used in Slave mode.
− Radar echo disappears
− The name of the soft button FUNC changes
to SERV (Service).
− The soft button USER appears.
−
The soft button EXIT RADAR appears.
Select the EXIT RADAR soft button for opening the
Utility Selections (Figure 2-7). Depending on system
configuration following types of utility selector are
available.
Select Operator System Shutdown on the Utility
Selections window.
Press and hold the power button for approx. 4 s.
The Radar is now powered off.