User's Manual
Table Of Contents
- 1 REGULATORY AND SAFETY INFORMATION
- 2 PREFACE
- 3 SPECIFICATIONS
- 4 GENERAL INFORMATION
- 5 OPERATION
- 5.1 CONVENTIONAL STATION CONFIGURATIONS
- 5.2 ENCRYPTED STATION CONFIGURATIONS
- 5.3 MODES OF OPERATION
- 5.4 ENCRYPTION FORMATS
- 5.5 P25 CONVENTIONAL CONFIGURATIONS
- 5.6 PROGRAMMABLE FEATURES FOR CONVENTIONAL STATIONS
- 5.6.1 Conventional Stations (Setup)
- 5.6.2 Main Station Data
- 5.6.3 Push-to-Talk Options
- 5.6.4 Other Potentiometer Settings
- 5.6.5 Carrier Control Timer
- 5.6.6 Squelch Tail Elimination
- 5.6.7 Drop Out Delay Timer
- 5.6.8 Control Shelf Options
- 5.6.9 Station Remote Control
- 5.6.10 Auxiliary Control Relay
- 5.6.11 Squelch Operated Relay
- 5.6.12 Channel Guard Monitor
- 5.6.13 System Module - Digital Signal Processing
- 6 MASTR III ADC STATION DESCRIPTION
MM102558V1 R1A
1.5 SAFETY SYMBOL CONVENTIONS
The following conventions are used to alert the user to general safety precautions that must be observed
during all phases of operation, service, and repair of this product. Failure to comply with these
precautions or with specific warnings elsewhere violates safety standards of design, manufacture, and
intended use of the product. M/A-COM, Inc. assumes no liability for the customer's failure to comply
with these standards.
The WARNING symbol calls attention to a procedure, practice, or the like, which,
if not correctly performed or adhered to, could result in personal injury. Do not
proceed beyond a WARNING symbol until the conditions identified are fully
understood or met.
CAUTION
The CAUTION symbol calls attention to an operating procedure, practice, or the like,
which, if not performed correctly or adhered to, could result in a risk of danger, damage
to the equipment, or severely degrade the equipment performance.
The NOTE symbol calls attention to supplemental information, which may improve
system performance or clarify a process or procedure.
The ESD symbol calls attention to procedures, practices, or the like, which could expose
equipment to the effects of Electro-Static Discharge. Proper precautions must be taken to
prevent ESD when handling circuit modules.
The electrical hazard symbol is a WARNING indicating there may be an electrical
shock hazard present.
8