User Manual

Step 1 : Remove the battery cap with cross screwdriver
Step 3 : Tighten the screw
Step 2 : Put the AAA batteries in battery box
1. Install the AAA batteries when open the box
Required Tool: Cross Screwdriver (Included)
Step 1 : Remove the battery cap with cross screwdriver
Step 3 : Tighten the screw
Step 2 : Put the AAA batteries in battery box
1. Install the AAA batteries when open the box
Required Tool: Cross Screwdriver (Included)
Step 1 : Remove the battery cap with cross screwdriver
Step 3 : Tighten the screw
Step 2 : Put the AAA batteries in battery box
1. Install the AAA batteries when open the box
Required Tool: Cross Screwdriver (Included)
Step 1 : Remove the battery cap with cross screwdriver
Step 3 : Tighten the screw
Step 2 : Put the AAA batteries in battery box
1. Install the AAA batteries when open the box
Required Tool: Cross Screwdriver (Included)
44
Collar Clamp
Tool required: 5 mm Allen wrench (not included)
Using a 5 mm Allen wrench, check that the collar clamp bolt(s) are tightened securely. This item is tightened and quality
inspected at the factory however there is a slight chance that the effects of shipping or handling may have caused the
bolt(s) to loosen.
WARNING:
Failure to properly install and/
or tighten the collar clamp
may cause the rider to lose
control and fall. If you are
having difficulty understanding
these instructions, please
contact Razor Customer
Service for assistance.
Note: The tension of the quick-release lever
can be adjusted by manually tightening or
loosening the Allen bolt. Be careful not to
over-tighten. You should always be able to
open and close the quick-release lever by
hand and the T-bar should slide freely when
the quick-release is open, unless T-bar is fully
extended.
1 To adjust the height of the handlebars,
open the quick-release lever and slide
the T-bar to the desired position. Close
the quick-release lever to lock into place.
When the T-bar is raised to the maximum
height, depress the push button located
directly below the quick-release lever to
unlock the T-bar.
Adjusting the Handlebar Height (Select models only)
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
ASSEMBLY AND SET-UP
q Install AAA batteries (Spark 2.0 only)
Tool Required: Phillips Screwdriver (not included)
2 Install the two (2) AAA batteries
in battery box.
1 Remove the battery cap. 3 Replace battery cap and
tighten the screw.