User Manual

5mm
5mm
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
5
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
5
Assembling the T-bar (S Spark only)
ASSEMBLY AND SET-UP
1 Loosen the collar clamp and slide
it upward. Insert T-bar into the fork
until it bottoms out on the headset
locknut.
Note: If necessary, carefully twist
the T-bar side to side while pushing
downward until T-bar bottoms out
on the headset locknut.
3
2
With the front wheel pointed
straight ahead, the handlebars
square to the front wheel and
the Razor logo facing the front,
tighten the clamp as shown.
Tighten securely.
WARNING: Failure to
properly install and tighten the
pivoting mechanism and the
plastic cover may cause the rider
to lose control and fall. If you do
not understand these instructions,
contact Razor customer care for
assistance.
WARNING: Do not
attempt to thread the handlebar
into the front fork thread. Tighten
clamp securely.