Instructions / Assembly

ManualsBrandsRazor ManualsOutdoorsA3 Scooter in Blue

Owner’s Manual

A-Type & Cruiser Scooters

v.2_09-11

NOTE: Manual illustrations are for demonstration purposes only. Illustrations

may not reﬂect exact appearance of actual product. Speciﬁcations subject to

change without notice.

Read and understand this entire manual before

allowing child to use this product!

For assistance contact Razor. DO NOT RETURN TO STORE.

Summary of content (6 pages)

PAGE 1
A-Type & Cruiser Scooters Owner’s Manual Read and understand this entire manual before allowing child to use this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. v.
PAGE 2
Contents Safety Warnings............................................................. 1 Before You Begin............................................................ 2 Assembly Instructions (A4 Only).................................... 2 Set Up And Usage Instructions (All Models).................. 3 Check Before Riding....................................................... 4 Safety Reminders........................................................... 5 Warranty................................................
PAGE 3
Before You Begin Remove contents from box. Inspect the contents of the box for scratches in the paint and/or dents that may have occurred during shipping. Because your scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. Grip T-tube Handlebar Steering tube quick-release WARNING: DO NOT USE NON-RAZOR PRODUCTS WITH YOUR SCOOTER. Razor scooters have been built to certain Razor design specifications.
PAGE 4
Set up and usage instructions (all scooters) q Unfolding the scooter for first time use. 1 Insert and secure the left and right handlebars by pressing the spring-loaded buttons and inserting them into the T-tube. 2 Make certain BOTH handlebars are properly locked onto the T-tube. 3 To release the folding mechanism, put one foot on the deck plate and push joint release lever down. Raise handlebars up until securely locked in the upright position.
PAGE 5
Check before riding q Collar Clamp (A4 ONLY) WARNING: Failure to properly secure the quick-release lever may cause the T-tube to telescope up or down while riding which may cause you to lose control and fall. Using a 5mm Allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt to loosen.
PAGE 6
Safety reminders PRE-RIDE CHECKLIST q q q q Loose Parts Check and secure all fasteners before every ride. Make sure the collar clamp, quick release lever, and handlebar spring buttons are locked properly in place before riding. Replacement Parts Replace worn or broken parts immediately. Call 1-866-GO-RAZOR for parts or visit www.razor.com. Be Careful! You will see people on TV and maybe even people you know doing tricks and stunts.