Instructions / Assembly

REPAIR AND MAINTENANCE
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
6
7-1
7-37-47-37-27-1 7-2
Right Side
7-2 Spacer
7-3 Bearing
7-4 Large Spacer
Fork
7-1 Coupling Bolt
Left Side
7-2 Spacer
7-3 Bearing
Fork
7-1 Bolt
1 Using two (2) 5 mm Allen wrenches, loosen the axle bolt.
Remove wheel and install replacement wheel.
(Note the sequence of the hardware)
Front Wheel Replacement
Tools Required: Two (2) 5 mm Allen Wrenches (Not included)
Note: Front wheel hardware
sequence
Turn power switch “OFF” before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch OFF
• Secure the unit under repair
• Exercise caution around
exposed parts
• Contact Razor customer service
if unsure about any repair or
maintenance
9-1 9-2
9-3
9-4
9-6
9-5
9-7
1 Using a Phillips screwdriver remove the six (6) screws and remove the
deck plate.
2 Disconnect battery. 3 Disconnect motor cables.
Note: Rear wheel/motor
hardware sequence
Left Side
9-1 Phillips Screws (2)
9-2 Motor Housing
Right Side
9-3 Spacer
9-4 Nut
Frame
9-5 Flat Washer
9-6 Lock-Washer
9-7 Locknut
Battery/Rear Wheel/Hub Motor Replacement
Tools Required: Phillips Screwdriver and Two (2) 13 mm Wrenches (Not included)
(Battery Replacement Steps 1-3)