Owners manual

ManualsBrandsRazor® ManualsFitness & SportsE300 Electric Scooter

REPAIR AND MAINTENANCE

Front Tire Replacement

Tools required: Two (2) 16 mm wrenches.

1 Using two (2) 16 mm wrenches,

loosen the front axle bolts by

turning the wrenches counter

clockwise. Remove wheel and

install replacement wheel. Note

the sequence of the hardware.

Note: Front wheel hardware

sequence.

7 Install the cable guide

bracket to the frame and brake

plate using bolt, washers, and

nut. Do not tighten.

8 Thread the brake cable through the brake adjuster barrel, through

the large spring, and into the small hole in the side of the anchor bolt.

Position the cable to the original location (as indicated by the slight

cable kink) and tighten securely.

9 Tighten the cable guide bracket bolt.

Tighten the locknuts on the rear axle. Test

the brake to verify proper function before

riding. Readjust as needed.

6 Verify chain is properly installed

on each sprocket and tensioner is

correctly positioned at the bottom

of the chain.

E300

5 Install the chain onto the rear

wheel sprocket. Slip wheel axle

into the frame slots. See rear wheel

hardware sequence on prior page.

Push the chain tensioner down to

create slack in chain. Hand tighten

rear axle locknuts.

Reassembly

Nut

Cable Guide

Bracket

Spacer

Frame

Washer

Bolt

Brake Plate

10 Replace the chain guard.

Right Side (Throttle)

9-5 - Spacer

9-4 - Washer

Fork

9-3 - Washer

9-2 - Spring Washer

9-1 - 16 mm Locknut

Left Side (Brake)