Owner’s Manual Read and understand this entire manual BEFORE riding! NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. For assistance contact Razor. DO NOT RETURN TO STORE. Please have product with you when calling for assistance.
Contents Safety Warnings............................................................. 1 Before You Begin............................................................ 2 Assembly and Set-Up.................................................. 3-4 Repair and Maintenance................................................. 5 Troubleshooting Guide................................................. 7-8 EcoSmart Metro Scooter Parts................................. 9-10 Safety Reminders......................................
Before You Begin Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the EcoSmart Metro Electric scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
Assembly and Set-Up q Attaching the Front Wheel A B B 1 Remove the packing material from the front fork. A 3 Insert the tab on the lock washer (B) into the hole on the front fork and tighten lock nuts using two 15mm wrenches. 2 Remove lock nuts (A) from the axle bolt and insert the wheel into the front fork. Lock washers should face outside of the fork. q Attaching the Handlebar 1 Face the handlebars forward with the throttle on the right and brake on the left.
Assembly and Set-Up Turn power switch “OFF” before conducting any maintenance procedures. q Adjusting the Brakes Tools required: 10mm open wrench 1 To adjust the brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2. WARNING: The brake is capable of skidding the rear tire and throwing an unsuspecting rider.
Repair and Maintenance qChecking Spoke Tension Spoke Flange Spoke 27 28 Hub Flange 4 Spoke Flange Rim Nipple Nipple 1 Verify spoke tension by grasping and shaking each spoke. Spoke should not be loose from hub. Look for any play between spoke flanges where it mates with hub. Try to turn nipple using your fingers. You should not be able to spin any nipple by hand.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
Troubleshooting Guide Problem Possible Cause Solution Scooter does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the scooter for the first time and up to 12 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on.
Troubleshooting Guide Problem Possible Cause Solution Sometimes the scooter doesn’t run, but other times it does Loose wires or connectors Check all wires around the motor and all connectors to make sure they are tight. Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Charger gets warm during use Normal response to charger use No action required. This is normal for some chargers and is no cause for concern.
ECOSMART METRO parts Keep your EcoSmart Metro electric scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. Handle grip 18. Charger port 2. Throttle 19. Kick stand 3. Handlebar 20. Control module 4. Brake lever (left) 21. 90 drum brake 5. Clamp 22. Rear wheel complete 6. Headset 23. Freewheel 7. Frame 24. Crankset 8. Protective cover 25. Chain 9.
ECOSMART METRO parts Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Safety reminders PRE-RIDE CHECKLIST q q q Loose Parts Check and secure all fasteners before every ride. Make sure steering stem clamp bolts are locked properly in place. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Brake Check the brakes for proper function. When you squeeze the levers, the brake should provide positive braking action.
