Caster Trike Owner’s Manual Read and understand this entire manual before riding! For assistance contact Razor. DO NOT RETURN TO STORE.
Contents Safety Warnings............................................................. 1 Before You Begin............................................................ 2 Assembly and Set-Up.................................................. 3-4 RipRider 360˚ Caster Trike Parts..................................... 5 Safety Reminders........................................................... 6 Warranty.........................................................................
Before You Begin Remove contents from box and check parts against part diagram below. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, or dents that may have occurred during shipping. Because the Rip Rider 360˚ was partially assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
Assembly and Set-Up q Attaching the Front Fork Required Tools: 13mm open wrench and 5mm allen wrench WARNING: Failing to properly tighten the steering bolt that attaches the handlebars can cause you to lose control and fall. 1 Remove the steering bolt and locknut from the frame assembly with a 13mm open wrench and 5mm allen wrench. 2 Insert the front fork into the frame assembly. 3 Be sure to properly align slot in headset tube with pin on fork as shown.
Assembly and Set-Up q Attaching the Rear Caster Wheels Required Tools: 5mm allen wrench 1 Locate the threaded hole on the rear underside of the frame. Screw caster wheel into hole. 2 Tighten with 5mm allen wrench. q Attaching the Seat Required Tools: (2) 5mm allen wrench 1 Remove the four coupling bolts from the frame using two 5mm allen wrenches. One on top and one on bottom. 2 Align four holes in seat with four holes in frame. Insert coupling bolts through the top and bottom of the frame.
RIPRIDER 360˚ Caster Trike Parts Keep your RipRider 360˚ running for years with genuine Razor parts. Visit our web site to purchase replacement parts. (Specifications subject to change without notice.
Safety reminders PRE-RIDE CHECKLIST q Loose Parts q Tire Care q Frame, Fork and Handlebars q Safety Gear Check and secure all fasteners before every ride. Make sure the steering bolt and casters are tight. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Check for cracks or broken connections.
