Flash RideR 360° ™ Owner’s Manual Read and understand this entire manual before riding! DO NOT RETURN TO STORE! NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. v.
CONTENTS Safety Warnings ............................................................ 1 Before You Begin ........................................................... 2 Assembly and Set-Up ................................................. 3-4 Set-Up and Usage Instructions ...................................... 5 Parts Breakdown ........................................................... 6 Safety Reminders .......................................................... 7 Warranty ..................................
BEfORE yOU BEGIN Remove contents from box and check parts against parts diagram found on page 6. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or dents that may have occurred during shipping. Because the Flash Rider 360˚ was partially assembled and packed at the factory there should not be any problems, even if the box has a few scars or dents.
ASSEMBLy AND SET-UP q Attaching the front fork Required Tools: 13mm open wrench and 5mm Allen wrench WARNING: Failing to properly tighten the steering bolt that attaches the front fork assembly to the frame assembly, can cause you to lose control and fall. 1 Remove the steering bolt and locknut from the frame assembly with a 13mm open wrench and 5mm Allen wrench. 2 Insert the front fork into the frame assembly. 3 Be sure to properly align slot in headset tube with pin on fork as shown.
ASSEMBLy AND SET-UP q Attaching the Rear Caster Wheels Required Tools: 5mm Allen wrench 1 Insert the caster bolt into the frame. If aligned correctly, the caster thread should go half way into the frame with no resistance. Note: Make sure the spring washer is on the caster bolt before inserting the caster. 2 Using a 5mm Allen wrench, tighten the hex bolt located on the underside of the wheel cover until the caster bolt is all the way inside the frame.
SET UP AND USAGE INSTRUCTIONS q Replacing the Spark Cartridge: Friction during sparking will eventually wear out the replaceable cartridge and cause the scooter to stop making sparks. Worn out cartridges must be replaced. WARNING: Do not attempt to replace cartridge immediately after riding as cartridge will be hot. Handle only when cool. WARNING: Keep fingers clear of Spark Bar hinge. 1 Using your thumbs, press tabs on both sides of the cartridge to release from the bracket.
fLASH RIDER 360˚ CASTER TRIkE PARTS Keep your Flash Rider 360˚ rolling for years with genuine Razor parts. Visit our website to purchase replacement parts. (Specifications subject to change without notice.
SAfETy REMINDERS PRE-RIDE CHECkLIST q Loose Parts q Tire Care q frame, fork and Handlebars q Safety Gear Check and secure all fasteners before every ride. Make sure the steering bolt and casters are tight. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Check for cracks or broken connections.