User Manual

≤30°
17-1
17-2
12
REPAIR AND MAINTENANCE
Hub Motor Replacement Cont.
Required Tools: 13 mm wrench, awl for opening out wire prongs.
14 Insert motor cable through hole
13 Tighten axle nut using the 13 mm wrench.
15 Open out wire prongs using an awl.
(Red & Black wires)
16 Insert motor cable wires into connector
18 Replace front cover plate.17 Connect motor cables.
20 Inspect back side for cables and wiring.
19 Make sure cables and wiring are
aligned correctly.