NOTE: The E100/E125/E150/E175 must be traveling up to 3 mph before motor will engage. Kick start up to 3 mph while applying the throttle to engage motor. OWNER’S MANUAL Read and understand this entire manual before riding! DO NOT RETURN TO STORE! NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice.
. . . . SAFETY WARNINGS WARNING: Riding an electric scooter does present potential risks and caution is required. Like any riding product, an electric scooter has inherent hazards associated with its use (for example, falling off or riding it into a hazardous situation). Like any riding product, electric scooters can and are intended to move and it is therefore, of course, possible to lose control or otherwise get into dangerous situations.
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
CHARGING BATTERY q Charging the Battery Charge the battery prior to use. • Initial charge time: 12 hours • Recharge time: up to 12 hours, even if the light turns green. Recommended maximum charging time is 24 hours. • Always charge the battery immediately after riding. • Fully charge battery before storing for extended periods of time. • Unplug charger from the wall outlet when not in use. • Failure to recharge battery periodically may result in a battery that will not accept a charge.
PRE-RIDE CHECKLIST q q Brake q Tires Check the brakes for proper function. When you squeeze the lever, the brake should provide positive braking action. Make sure that brakes are not rubbing. Frame, Fork and Handlebars Check for cracks or broken connections. Although broken frames are rare, it is possible for an aggressive rider to run into a curb or wall and wreck, bend or break a frame. Get into the habit of inspecting your scooter on a regular basis.
REPAIR AND MAINTENANCE Turn power switch “OFF” before conducting any maintenance procedures. q Adjusting the Brakes Tools required: 10 mm open wrench 1 To adjust brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2.
REPAIR AND MAINTENANCE Note: Rear wheel hardware sequence 18-1 4 Remove wheel and install replacement wheel. (Note the sequence of the hardware) 5 Push the chain tensioner down to install the chain on both sprockets. 6 With two 13 mm open wrenches, re-tighten the locknuts. E100 Rear 7 Re-attach the chain guard.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Does Not Work Out Of The Box Unit must be traveling up to 3 mph before motor will engage Kickstart to 3 mph while applying the throttle to engage motor Loose connection(s) Check for loose connections/wires underneath the deck plate Loose connection(s) Check for loose connections/wires underneath the deck plate No Longer Works Check power to wall outlet and/or try a different outlet Charger not working Check lights on charger: Plugged into wal
E100/E125/E150/E175 PARTS 01 Handlebar grip (right/left) 02 Single speed twist grip throttle 02-1 Sleeve 10 Front wheel complete (See pg. 5 for hardware sequence) 18 Rear wheel complete (See pg. 6 for hardware sequence) 11 Battery tray 19 Chain Tensioner 03 Handlebar stem 12 Control module 20 Chain 13 On/Off switch 21 Chain Guard 14 Charger port 22 Battery (2) 24V/4.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. WARRANTY Razor Limited Warranty The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase.