Owner’s Manual Read and understand this entire manual BEFORE riding! NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. For assistance contact Razor. DO NOT RETURN TO STORE.
Contents Safety Warnings............................................................. 1 Before You Begin............................................................ 2 Assembly and Set-Up.................................................. 3-5 Repair and Maintenance................................................. 6 Troubleshooting Guide.................................................... 7 Ground Force Drifter Parts........................................ 9-10 Safety Reminders................................
Before You Begin Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the Ground Force Drifter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. Estimated Assembly and Set-Up Time Razor recommends assembly by an adult.
Assembly and Set-Up Turn power switch off before conducting any maintenance procedures. WARNING: Failure to properly install and tighten the screws, nuts and bolts that affix the steering wheel and seat can cause you to lose control and crash. q Attaching the Steering Wheel 1 Untangle the wires and insert the steering wheel into the steering column. WARNING: DO NOT flip the Ground Force Drifter upside down to tighten steering axle bolts as it may damage control wires from the steering wheel.
Assembly and Set-Up Turn power switch off before conducting any maintenance procedures. q Self Adjusting Chain Tensioner Note: Proper alignment of the chain must be maintained. If the chain is adjusted properly, but is noisy or rough running, check alignment of the sprockets. The drive -shaft sprocket can be adjusted slightly from side-to-side by loosening the set screw. Note that a key maintains the drive position to the shaft.
Assembly and Set-Up Turn power switch off before conducting any maintenance procedures. WARNING: Failure to properly adust and tighten the screws, nuts and bolts that affix the wheels can cause you to lose control and crash. q Replacing the Wheels Front and rear wheel installation and removal are the same. Loosen Tighten 1 To remove a wheel, remove the self-locking nut (13mm socket or wrench required for front wheels, 17mm for the rear wheels). Tap the wheel to remove.
Repair and Maintenance q Battery Care and Disposal Do not store the battery in temperatures above 75° or below -10° F. CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a lead-acid battery in your regular household trash.
Troubleshooting Guide Problem Product does not run. Possible Cause Undercharged battery. Solution Charge the battery. A new battery should have been charged for at least 18 hours before using the product for the first time and up to 12 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port and that the charger is plugged into a functioning wall outlet. Charger is not working.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. WARNING: This product contains or emits chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Ground Force Drifter Parts Keep your Ground Force Drifter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.
Ground Force Drifter Parts 10
Safety reminders PRE-RIDE CHECKLIST q Loose Parts q Frame, Fork and Steering Wheel q Brake q Safety Gear q Check and secure all fasteners before every ride. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Check the brake for proper function. When you squeeze the lever, the brake should provide positive braking action.
