Instructions

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.

MX125

BATTERY REPLACEMENT

INSTRUCTIONS

PART# W20136401003

Using a Phillips screwdriver, remove the six (6) screws

on the battery cover. There are three (3) on each side.

A. Phillips screwdriver B. 4 mm Allen wrench

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any

assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Remove both battery covers and set aside.

Step 1

Required Tools: (Not included)

WARNING

Step 2

PAGE 1
MX125 BATTERY REPLACEMENT INSTRUCTIONS PART# W20136401003 Required Tools: (Not included) A. Phillips screwdriver B. 4 mm Allen wrench WARNING CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage. Step 1 Step 2 Using a Phillips screwdriver, remove the six (6) screws on the battery cover. There are three (3) on each side.
PAGE 2
MX125 BATTERY REPLACEMENT INSTRUCTIONS PART# W20136401003 Step 3 Step 4 Using a 4 mm Allen wrench, loosen and remove the two (2) hex bolts from the battery bracket. Locate and disconnect the battery from the controller. Step 5 Note Remove the battery from the unit. The longer side of the battery bracket should be positioned on the left and the shorter side on the right. Step 6 Reverse the procedures • Insert new battery in place and connect it to the controller.