Owner's manual

Front Fork Assembly
Front Wheel Assembly
Steering Bolt
Rear Caster Wheels
Seat
Barcode
Location
2
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the bottom of the frame) available for better assistance.
BEFORE YOU BEGIN
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RIPRIDER 360˚.
The RipRider 360˚ has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible and will
void your warranty.
Remove contents from box and check parts against part diagram below. Remove the foam separators that protect the
components from damage during shipping. Inspect the contents of the box for scratches in the paint or dents that may
have occurred during shipping. Because the RipRider 360˚ was partially assembled and packed at the factory there
should not be any problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
q Required Tools
(2) 5mm
Allen wrenches
(included)
10mm and 13mm
wrench
(included)
PRODUCT I.D. CODE
1. Bottom of Frame
2. UPC Side of Box (not shown)