Owner's manual

3
WARNING: Failing to
properly tighten the steering bolt
that attaches the handlebars can
cause you to lose control and fall.
ASSEMBLY AND SET-UP
1 Remove the steering bolt and
locknut from the frame assembly
with a 13mm wrench and 5mm
Allen wrench.
2 Insert the front fork into the
frame assembly.
q Attaching the Front Fork
Required Tools: 13mm wrench and 5mm Allen wrench
4 Re-insert the steering bolt and
secure with locknut using a 13mm
wrench and 5mm Allen wrench.
3 Be sure to properly align
slot in headtube with pin on
front fork as shown.
1 Using (2) 5mm Allen wrenches,
remove coupling bolt and discard
plastic insert.
2 Insert the rear frame to the
frame assembly and using (2) 5mm
Allen wrenches, securely tighten
coupling bolts.
q Attaching the Frame
Required Tools: (2) 5mm Allen wrenches