TK SERIES FREESTANDING SPEAKERS Installation & Operation Manual
Introduction Congratulations on your purchase of RBH Sound freestanding speakers! Your speakers are the result of many years of research and development dedicated to producing high quality products for home audio and audio/video systems. This manual contains features, setup recommendations and specifications for the TK-5CT, TK-515C and TK-5C freestanding speakers. We recommend you thoroughly read through the material contained in this manual before connecting your speakers.
Care and Cleaning To maintain speaker appearance, we recommend wiping them down with a clean damp soft cloth. To clean dust from the grille cloth, use a vacuum with a brush attachment. Features At the heart of the TK Series speaker system is a proprietary fiberglass cone bass/midrange driver (speaker). The fiberglass cone resists flexing better than typical speaker cone materials, thereby providing highly articulate and accurate reproduction of the audio signal.
Attaching Speaker Wires (continued) If not using a banana jack, simply loosen the binding nut to allow the hole in the side of the terminal to become exposed. Strip ¼-inch of the insulation from the end of the speaker wire and insert the exposed wire end into the now exposed hole in the side of the terminal. Tighten the binding nut by turning the nut clockwise until the speaker wire is secured. Repeat for the other speaker wire(s) as necessary.
Room Setup Suggestions Rear Surround Speakers The TK-5C 2-way Bookshelf Speakers may be placed either above, behind or to the sides of the listening position. The listening position should be centered between the surround speakers. For best performance you may want to experiment with angling the surround speakers either towards or away from the listening position. Subwoofer Placement of the subwoofer will largely determine quality, quantity, and extension of the bass frequencies within your listening room.
Specifications Model TK-5CT TK-515C TK-5C Frequency Response: 45Hz – 20Hz 60Hz – 20Hz 60Hz – 20Hz Sensitivity: 87dB 89dB 86dB Power Handling: 150 Watts 120 Watts 100 Watts Woofer: 8” Kraft Pulp Woofer Dual 5¼” Fiberglass Mid-Range Woofers 5¼” Fiberglass Mid-Range Woofer Dual 5¼” Fiberglass Mid-Range Woofers Tweeter: 1” Fabric Dome Tweeter 1” Fabric Dome Tweeter 1” Fabric Dome Tweeter Impedance: 8 Ohms 8 Ohms 8 Ohms Crossover Frequencies: 120Hz / 3000 Hz 3000 Hz 3000 Hz Dimens
Warranty Your RBH Sound TK Freestanding Speakers are covered by a limited warranty against defects in materials and workmanship for a period of 5 years from the original date of purchase. This warranty is provided by the authorized RBH Sound dealer where the speaker was purchased. Warranty repair will be performed only when your purchase receipt is presented as proof of ownership and date of purchase.
TM Redefining the Way You Experience Sound. 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (800) 543-2205 • Fax: (801) 543-3300 www.rbhsound.com It is RBH Sound policy to continuously incorporate improvements into our products; all specifications are subject to change without notice. Copyright © 2006 RBH Sound. All Rights Reserved.