M SERIES ON-WALL SPEAKERS WM-24 and WM-30 Owners Manual
Introduction Congratulations on your purchase of an RBH Sound M Series WM-24 or WM-30 onwall speaker! Your speaker is the result of many years of research and development dedicated to producing high quality products for home audio and audio systems. This manual contains features, setup recommendations and specifications for the M Series WM-24 and WM-30 wall-mount speaker. It is recommend you thoroughly read through the material contained in this manual before connecting your speakers.
Care and Cleaning To maintain speaker appearance, we recommend wiping them down with a clean damp soft cloth. To clean dust from the grille cloth, use a vacuum with a brush attachment. Features At the heart of the M Series speakers are proprietary aluminum woofers and midrange drivers. This special aluminum cone material combines stiffness, low mass and selfdamping properties to allow uncolored presentation of the program material.
System Setup In order to extract the best possible sound from your speaker system, it is important to determine where the speakers will sound best in your listening room. Room reflections from the floor, ceiling and side walls influence the balance, imaging and overall sonic quality at the listening position. Experiment with speaker placement to determine which location offers the best overall sound.
System Setup (continued) 4
Mounting Bracket Using the enclosed template, mark your desired speaker location. NOTE: the bracket is offset to allow for the slide mount of the speaker onto the bracket. The offset allows the speaker to be centered when mounting is complete. If mounting in a stud-less drywall location, use the enclosed self-tapping drywall augers and screws. Start the auger in the drywall location with a few slight taps from a hammer, then screw down snugly with a screwdriver.
Speaker Mounting To mount the speaker to the bracket, screw the supplied mounting knobs into the holes shown below (screw mounts), then tighten with a flat blade screwdriver. Attach the speaker wire observing polarity, and then fit the mounting knobs into the speaker mount opening of the bracket (shown in the illustration on the previous page. The speaker will mount centered when the mounting knobs are slid into place on the bracket in the direction shown by the arrows in the illustration below.
Specifications Model WM-24 WM-30 Frequency Response: 50Hz-20kHz ±3dB 45Hz-20kHz ±3dB Sensitivity: 90dB 90dB Recommended/ Rated Power: 75-120 Watts 75-120 Watts Woofer(s): (2) 4” Active Aluminum Cone (2) 4” Passive Aluminum Cone (2) 4” Active Aluminum Cone (2) 4” Passive Aluminum Cone Tweeter: (1) 1” Fabric Dome (1) 1” Fabric Dome Impedance: 6 Ohms 6 Ohms Crossover Frequencies: 3000 Hz 3000 Hz Finish: Black Brushed Aluminum Black Brushed Aluminum Grille: Black or Silver Cloth Bla
Troubleshooting Situation: Probable Cause: Solution: No sound from speakers Speaker wire not connected Make sure wire is connected at both the speaker and the amplifier observing proper polarity Speaker selector on amplifier is not on Activate proper selector on amplifier Balance control on receiver or pre-amp is not centered Place balance control in the center No sound from speaker Speaker wire not securely Check all connections at connected amplifier and speakers Very little bass and/or imaging
TM Redefining The Way You Experience Sound. 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (800) 543-2205 • Fax: (801) 543-3300 www.rbhsound.com It is RBH Sound policy to continuously incorporate improvements into our products; all specifications are subject to change without notice. Copyright © 2007 RBH Sound. All Rights Reserved.
