User Manual

RBP Chemical Technology, Inc.
RBP Chemical Technology, Inc.RBP Chemical Technology, Inc.
RBP Chemical Technology, Inc.
150 S. 118
th
Street  P.O. Box 14069
Milwaukee, WI 53214-0069
www.rbpchemical.com
Corporate: 414-258-0911
Fax: [phone]
RBP East: 508-865-0800
This product should be used only for its intended purpose. The information stated above is based on our laboratory tests and
experience, and is accurate to the best of our knowledge. Since actual use is beyond our control, the recommendations or
suggestions are made without warranty, expressed or implied.
Product Data Sheet
Date:
03/21/12
Supersedes: 08/18/11
PRODUCT #: J5075
PLASTIC PLATE DESENSITIZER
Plastic Plate Desensitizer
Description:
Designed to prevent scumming
and tinting problems that typically occur when
running plastic or polyester plates with a conventional fountain solution. PLASTIC
PLATE DESNSITIZER contains ingredients that adhere to the non-image areas of silver
emulsion plastic plates and promote a "water loving" environment for the non-image
area.
Directions for Use:
Add 0.5
-
1.5 ounces of
PLASTIC PLATE DESENSITIZER
to each gallon of press ready
mix. A good starting point is 1.0 ounces per gallon.
PLASTIC PLATE DESENSITIZER is compatible with both metal and plastic type plates.
RBP recommends using with its UNITROL
®
192. Call an RBP Technical Service
Representative for more information.
Specifications:
Appearance:
Clear white
liquid
Density:
10.0
lbs/gal
VOC Content:
(EPA Method 24)
None
Flash Point:
None