User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b

Shrink the tube completely. Apply

heat carefully and blot away any CA

that is forced out, onto a paper towel.

If the glue catches fire remove the

lighter and blow out.

Repeat for the other control rod.

PREPARE THE ELECTRONICS

PREPARE THE ELECTRONICSPREPARE THE ELECTRONICS

PREPARE THE ELECTRONICS

If your motor did not come with 2mm

bullets,, add them now. Also note that

Also note that Also note that

Also note that

your power combo may have come with

your power combo may have come with your power combo may have come with

your power combo may have come with

a different motor, same instructions

a different motor, same instructions a different motor, same instructions

a different motor, same instructions

apply

applyapply

apply.

As an option

As an optionAs an option

As an option: you can solder the motor

leads directly to the ESC. If choosing

this option, female plugs from the ESC

would be removed and wire insulation

stripped back. Solder and protect with

a single piece of heat shrink tubing on

each wire

Solder them on and prepare 3 small

pieces of shrink tubing