User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b
20
Bind your Radio to the Receiver,
center all trims, set up the proper
direction and controls for the Elevons,
set sub trims so servos arms are 90
degrees to the servo and determine
correct motor rotation.
NOTE: if you chose to solder your
motor wires to the ESC you can change
the motor direction via the transmitter
programming method.
Attach the quick link to the Servo
arms. For the arms included with the
Twisted Hobbys CS-40D, use one hole
in for mild control (shown) and outer
most hole for extreme control
On a piece of cardboard or other soft
surface push the pin onto the keeper.
NOTE: the concaved side is UP in
this picture.