User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b
21
PREPARE SERVOS
PREPARE SERVOSPREPARE SERVOS
PREPARE SERVOS
Add thin (skim) layer of Welders to the
three sides of the Servos that come into
contact with the surfaces of the cutouts
in the wing.
NOTE: The method being described
will allow for removal of the servos yet
hold them tight otherwise.
Set the servos aside to allow the skim
coating of Welder to dry thoroughly,
you should allow a couple hours for
this, longer if possible.
Put a small bead of Welders on the
matching surfaces of the wing cutouts.