User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b
22
Smooth the glue out to a thin coat and
allow to dry a couple hours, longer if
possible.
NOTE: Once the glue has dried, there
will still be a “sticky” surface between
the servos and wing cut out, hold them
securely in place, but still remove-able
if needed
STEP
STEP STEP
STEP 5
55
5
Locate the lower fuselage doubler
Position it as shown. The back edge
but be flush with the cutout in the
wing. This edge forms one of the motor
mount surfaces, making it flush will
ensure a nice flat surface for the motor
mount to fasten to later.