User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b
36
Since the battery is in a fixed position
on this plane, you will need to balance
by locating the ESC and Receiver
appropriately.
Move the components around until the
plane balances 13mm back from the
front spar.
Note: CG range on Flying wings is
much narrower that on conventional
planes, take your time and get this as
close as you can to the recommended
spot.
If using all the Twisted Hobbys’ stuff,
and the 250mAh Twisted Hobbys’
LiPo battery, your ESC and Receiver
should be located approx as shown in
regards to the front to back position.
Placement from side to side is not as
critical, but you should keep lateral
balance in mind. You could also
mount all you gear on the bottom side
if desired.