User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b
39
Control Throws
Control ThrowsControl Throws
Control Throws
3D / Combat Flight :
Max Allowed as determined by Rudder Cut-Outs – SEE PICTURES BELOW
60 to 75% expo
Sport :
20 degrees all surfaces
30 to 45% expo
Depending on your Radio the Elevon mix / setting may “overdrive” the controls surfaces.
It is very important to determine the max travel while the transmitter sticks are in
the extreme corners of the Gimble. Individual Elevator and individual Aileron control
will not be close to the limits at all, so do not set the max travel for the individual channels
in this manner. Failure to set the limits as a COMBINED CONTROL could result in
damage to the servos.
FULL UP
FULL UP FULL UP
FULL UP FULL UP
FULL UP FULL UP
FULL UP &
&&
& LEFT
LEFT LEFT
LEFT
As shown above “Full Up” does not reach the limits
As shown above “Full Up” does not reach the limits As shown above “Full Up” does not reach the limits
As shown above “Full Up” does not reach the limits
established by the cut out in the rudder fin. However in
established by the cut out in the rudder fin. However in established by the cut out in the rudder fin. However in
established by the cut out in the rudder fin. However in
the “Full Up
the “Full Up the “Full Up
the “Full Up &
&&
& Left” situation the
Left” situation the Left” situation the
Left” situation the Elevon
ElevonElevon
Elevon is set to just
is set to just is set to just
is set to just
bottom out at the position of the cut out. C
bottom out at the position of the cut out. Cbottom out at the position of the cut out. C
bottom out at the position of the cut out. Care must be
are must be are must be
are must be
taken when
taken when taken when
taken when programming
programmingprogramming
programming as to not overdrive the servos. If
as to not overdrive the servos. If as to not overdrive the servos. If
as to not overdrive the servos. If
you are unsure of the travel loosen the screw in the quick
you are unsure of the travel loosen the screw in the quick you are unsure of the travel loosen the screw in the quick
you are unsure of the travel loosen the screw in the quick
link and experiment with your radios
link and experiment with your radios link and experiment with your radios
link and experiment with your radios programming
programmingprogramming
programming until
until until
until
you are satisfied that it will not overdrive the control
you are satisfied that it will not overdrive the control you are satisfied that it will not overdrive the control
you are satisfied that it will not overdrive the control
surface.
surface.surface.
surface.