User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b

SAFETY NOTES

SAFETY NOTESSAFETY NOTES

SAFETY NOTES

 Before assembling and flying this model, read carefully any

instructions and warnings of other manufacturers for all the

products you installed or used on your model, especially radio

equipment and power source.

 Check thoroughly before ever flight that the airplanes’

components are in good shape and functioning properly. If you

find a fault do not fly the model until you have corrected the

problem.

 Radio interference caused by unknown sources can occur at any

time without notice. In such a case, your model will be

uncontrollable and completely unpredictable. Make sure to

perform a range check before every flight. If you detect a control

problem or interference during a flight, immediately land the

model to prevent a potential accident.

 Youngsters should only be allowed to assemble and fly these

models under the instruction and supervision of an experienced

adult.

 Do not operate this model in a confined area.

 Do not stand in line with, or in front of a spinning propeller and

never touch it with any object.

IMPORTANT: PRIOR TO ANY ASSEMBLY

Please Note: after removing kit from shipping box, lay

each piece flat on a hard surface, this will allow the

airframe to straighten out if lightly bent from

shipping. Do not worry since EPP is very pliable and

can be bent back if out of shape.