User manual Crack WING ORANGE RC Factory

Rev: 2013.02.02.v001b

THE BUILD

THE BUILDTHE BUILD

THE BUILD

CONSTRUCTION METHODS:

Building surface should be at least 2ft x 4ft and flat. Weights or some small heavy objects will be

handy for holding things in place during the time glue is setting.

Welders glue is used exclusively for this build, except for the control rod ends, which are glued

with thin CA. When usin

When usinWhen usin

When using the Welders glue, apply

g the Welders glue, apply g the Welders glue, apply

g the Welders glue, apply a thin film to each surface

a thin film to each surfacea thin film to each surface

a thin film to each surface, allow to sit for

, allow to sit for , allow to sit for

, allow to sit for

approx

approx approx

approx five

fivefive

five minute

minute minute

minutes

s and then assemble

and then assemble and then assemble

and then assemble.

. Note that this method will create a nearly instant bond,

so locate carefully when bringing the two pieces together. If alignment is necessary while gluing

the two pieces together, do not allow the glue to tack up, simple apply and join immediately, you

will have several minutes to locate the two parts before the glue sets up. In most cases the parts

being glued can be handled with care in 30 minutes, full cure is approx 24 hours.

STEP 1

STEP 1STEP 1

STEP 1

On a flat building surface (covered with

Parchment or Wax paper) locate the

two wing halves and test fit them

together. When assembling you want

the cut outs for the spars to line up

with each other.

Apply a thin layer of Welders to the

contact area of both wing halves, allow

to tack up for approx 10 minutes.