User manual

Transmitter | 31
16.3.8.2 Gear channel
The following setup will enable DX6i users to toggle from SPORT to EXPERT MODE
using the GEAR CHANNELonthetransmitter(Thesemodeshavebeenselectedasit
willbethemostcommonlyusedbypilotsusingtheirowntransmitter).
1. Beginbyassigninganewmodelandverifymodeltypeisselectedas“Airplane”.
2. Enter
“Adjustlistmenu”» “Traveladjust”» scrollto“Gear”.Withgearswitch
inposition“0”,highlightandadjustthetravelto“0%”.Referto [ Fig. 13 ]:
3. The GEAR channel is now set to be programmed.
NOTE: To enable toggling between BEGINNER and SPORT
mode simply adjust the travel in GEAR switch position ”0”
to ”100%” and adjust the travel of GEAR switch position ”1”
to ”0%”.
Fig. 13
16.3.8.3 Flap/gyro channel
The following setup will allow pilots to toggle between NORMAL and ALTITUDE
HEIGHT HOLD modes when in SPORT ightmodeonlytoggling.ACROBATIC mode
willbeomitted(Thesemodeshavebeenselectedasitwillbethemostcommonlyusedby
pilotsusingtheirowntransmitters).
1. Enter
“Adjustlistmenu”» “Enterapsscrolltoap–norm”» adjustto“5”.
Carefullyobservethedirectionofthearrow.See [ Fig. 14 ].
2. Scrollto“Flap-land”» adjustto“100”.Carefullyobservethedirectionofthearrow.
See [ Fig. 14 ].
3. Exitthe“Flap”menu» scroll » enter
“Setuplist”.Scrollandenter “Reverse”.
Youwillnowneedtoreversethe“Flap”channel.See [ Fig. 15 ].
4. Exitthe“Setuplist”menu.
5. The“Flap”channelisnowsettobeprogrammed.
To enable toggling between ACROBATIC mode and NORMAL
flight mode simply switch the values between NORM and
LAND. Also, do not reverse the FLAP CHANNEL.
Fig. 14
Fig. 15