User manual

Transmitter | 37
16.4.6.11 Notes
Mode Channel Switch Function
AUX-1 Channel 5
Position 1: BEGINNER MODE
Position 2: SPORT MODE
Position 3: EXPERT MODE
AUX-2 Channel 6
Position 1: ACROBATIC MODE
Position 2: NORMAL FLIGHT
Position 3: ALTITUDE HEIGHT HOLD MODE
AUX-3 Channel 7
Position 1: TRIGGER OFF
Position 2: TRIGGER ON (optionalandcan
be ignored during learning; 3 seconds timeout
duringlearning!)
To start test and/or flying in SPORT mode, make sure that
AUX-1 is in centre position (position 2) and AUX-2 is in
centre position (position 2).
THROTTLE must be at the lowest position.
16.4.7 Verify learning
IMPORTANT! Test 1 must be completed before flying!
Ensure the »Xtreme stands on a level surface!
1. Test 1 - Gyro reset
> Move AILERON stick right with ELEVATORstickup(toprightcorner).
> GYRO shouldinitialize(thestatusLEDofthe»Xtremeturnsgreen).
2. Test 2 - Orientation LEDs
> Move AILERON stick right with ELEVATORdown(bottomrightcorner).
> The orientation LEDs turn on or off depending on their state. Repeat the steps to switch
their states.
3. Test 3 - Flight modes
> Toggle AUX-1 (throttle must be at zero)
> Positions:
» Position1=Greenblinking(Beginnermode)
» Position2=Orangeblinking(Sportmode)
» Position3=Redblinking(Expertmode)
4. Test 4 - Acrobatic/Normal/Height hold
Test 4 must be performed in SPORT mode!
> Togglethesecondassigned3positionswitch(AUX-2):
» Position1=FastblinkingstatusLED(acrobaticmodeactivated)
» Position2=Normalblinking(normalightmode)
» Position3=Fastblinking(altitudeheightholdmode)
To turn off altitude height hold mode toggle the second
assigned switch (AUX-2) back to position 2 (centre) and
move the throttle stick up or down.