User manual

52 | Maintenance, Care And Repair
19.2.2 Mode 1
Theuseofthesuppliedstocktransmitterisdescribedhere.Foryourowntransmitterrefer
toitsuserinstructionsandyourowncongurationrespectively.
1. Placethe»Xtremeontoanasataspossiblelevelsurface.
2. Poweronthetransmitterandconnecttheightbattery.
3. Move the THROTTLE/AILERONleverdiagonallyintotherightbottomposition,and
move the ELEVATOR/RUDDERleverfullyupvertically.See [ Fig. 28 ].
4. Hold the levers at their positions until the transmitter emits an ACOUSTIC SIGNAL
and the »Xtreme’s STATUS LED TURNS SOLID GREEN.
5. The calibration has been completed, no drift should be observed. In case the »Xtreme
stilldrifts,thesensormaybedefectiveorvibrationsstillremain.
» Replace all 4 motors.
19.2.3 Mode 2
Theuseofthesuppliedstocktransmitterisdescribedhere.Foryourowntransmitterrefer
toitsuserinstructionsandyourowncongurationrespectively.
1. Placethe»Xtremeontoanasataspossiblelevelsurface.
2. Poweronthetransmitterandconnecttheightbattery.
3. Keep the THROTTLE/RUDDER lever at zero and move the AILERON/ELEVATOR
leverdiagonallyintothetoprightcorner.See [ Fig. 29 ].
4. Hold the levers at their positions until the transmitter emits an ACOUSTIC SIGNAL
and the »Xtreme’s STATUS LED TURNS SOLID GREEN.
5. The calibration has been completed, no drift should be observed. In case the »Xtreme
stilldriftsthesensormaybedefectiveorvibrationsstillremain.
» Replace all 4 motors.
Mode 1
Fig. 28
Mode 1Mode 1Mode 2
Fig. 29