RC4WD TF2 LWB
Recommended Tools Hex Drivers (1.5mm, 2mm, 2.5mm) Thread Lock Cross Wrench (M2, M3, M4) Long Nose Pliers Phillips Driver Tips for Assembly Use good quality hex drivers to avoid stripping screw heads. Use thread lock when putting metal screws into metal parts. Note: Steps marked with an asterisk (*) require thread lock. Use thread lock sparingly. Do not over tighten screws otherwise you may strip the thread.
Warranty RC4WD non-electrical products are warranted to be free of defects in materials and workmanship when new. Our limited warranty does not cover damages due to normal wear and tear, user error of assembly or installation, user modifications, user's failure to perform routine maintenance, addition of aftermarket parts or option parts. This warranty lasts 30 days after arrival for original purchaser.
All hardware should be taken from Bag C ●1* M3 x 6mm BHCS ●2* M3 x 8mm BHCS 1 RC4WD TF2 LWB
Plastic parts can be found in Bag D ●3 M3 x 14mm BHCS ●4 M3 x 12mm BHCS ●5 M3 x 15mm Step Screw M3 Locknut 2 RC4WD TF2 LWB
●6* M3 x 10mm BHCS ●7* M3 x 8mm BHCS 3 RC4WD TF2 LWB
●8* M3 x 12mm BHCS M3 x 10mm BHCS ●9* M3 x 8mm BHCS 4 RC4WD TF2 LWB
●10* M3 x 10mm BHCS ● 11* M3 Locknut M3 x 8mm BHCS M3 x 8mm BHCS M3 Locknut M3 x 15mm Step Screw M3 x 15mm Step Screw 5 RC4WD TF2 LWB
●12* M3 x 12mm BHCS M3 x 14mm M3 x 14mm ●13* M3 x 8mm BHCS M3 x 12mm BHCS M3 x 10mm BHCS M3 x 8mm BHCS 6 RC4WD TF2 LWB
●14* M3 x 10mm BHCS ●15* M3 x 8mm BHCS M3 x 8mm BHCS M3 x 8mm FHCS 7 RC4WD TF2 LWB
●16* M3 X 6mm FHCS ●17* M3 x 8mm FHCS 8 RC4WD TF2 LWB
●18* M3 x 14mm BHCS ●19-1 1 Optional (Not used) 2 Step 19-2 3 Step 24 9 RC4WD TF2 LWB
● 19-2 M3 x 6mm FHCS ●20* M3 Drive Shaft Pin 10 RC4WD TF2 LWB
●21* M3 x 6mm FHCS Bearing ●22 M3 x 8mm BHCS 11 RC4WD TF2 LWB
●23 M3 x 8mm FHCS Attach leaf springs to front and rear axles Note: The smaller helper leafs can be fitted below the main leaf to stiffen the suspension ●24 M3 x 16mm BHCS M3 Locknut Remove the screws first 12 RC4WD TF2 LWB
●25 M3 Locknut M3 x 15mm Step Screw ● 26 M3 x 15mm Step Screw M3 Locknut 13 RC4WD TF2 LWB
● 27 M3 x 6mm FHCS ● 28-1 80mm Shock M3 Locknut M3 x 18mm BHCS 2mm Spacer 14 RC4WD TF2 LWB
● 28-2 M3 Locknut 3mm Spacer M3 x 16mm BHCS ● 29 M3 x 12mm BHCS 100mm Shock 2mm Spacer M3 x 16mm BHCS 15 RC4WD TF2 LWB
● M3 Drive Shaft Pin ● 16 RC4WD TF2 LWB
● 31-2 M3 x 10mm BHCS M3 x 10mm BHCS ● 32 M3 Drive Shaft Pin 17 RC4WD TF2 LWB
Install drive shaft rings ● 33 Locking Ring CORRECT ALIGNMENT INCORRECT ALIGNMENT Please check alignment when installing your drive shafts.
● 34 Short Drive Shaft M3 Drive Shaft Pin ● 35 M3 x10mm Set Screw M3 x15mm Set Screw 60mm Link 101mm Link 19 RC4WD TF2 LWB
36 .
● 38 M3 Locknut M3 x 10mm BHCS M3 x 22mm BHCS ● 39 21 RC4WD TF2 LWB
40 M3 x 20mm BHCS 41 M3 x 20 22
42 M3 x 1 0mm BHCS 43 M3 Locknut M3 x 14 mm BHCS 23 RC4WD TF2 LWB
● 44 M3 x 15mm Set Screw ● 45 M3 x 15mm Set Screw 24 RC4WD TF2 LWB
● 46 Wheel disassembly shown 1. Insert internal beadlock ring into tire. 2. Install wheel front and back. NOTE: Ensure front and back side spokes align with each other. 3. Use the included longer hardware to help aid in tire and wheel installation. Be sure to slowly tighten the nuts on the longer hardware until you are able to begin installing the included shorter hardware. 4. Install the correct shorter length hardware into the remaining holes.
5. Begin to tighten the hardware into a star shape pattern to fully seat the tire to the wheel properly. 1 6 4 3 2 5 7. Now you can remove the longer hardware. 6. Your wheel and tire should be fully seated as shown: M2 x 14mm Cap Screw 8. Install the correct shorter hardware. 9.
● 47 is not included ●48 M3 x 8mm 27 RC4WD TF2 LWB
Drive it like you built it! 28 RC4WD TF2 LWB
Spare Parts Z-B0029 TF2 Plastic Body Posts Z-S0592 TF2 Fuel Cell Radio Box Z-S0593 TF2 Bumper Mounts Z-S0594 TF2 Front Tube Bumper Z-S0595 TF2 Rear Tube Bumper Z-S0597 TF2 Shock Hoops Z-S0598 TF2 Tcase Mounts Z-U0024 TF2 Scale Transfer Case Z-U0025 TF2 Scale 2 Speed Transmission Z-S0600 TF2 2mm Spacers Z-S0601 TF2 Yota Steering Links Z-A0058 Yota Front Axle Z-A0061 Yota Rear Axle Z-S0027 Yota 1/10 Axle Ring & Pinion Gears Z-D0004 The Ultimate Scale Shocks 80mm (Silver) Z-D0001 The Ultimate Scale Shocks 100m
Optional Parts Z-S0565 3 Link Kit For Trail Finder 2 Front Axle w/Panhard Setup Z-S0603 4 Link Kit for Trail Finder 2 Rear axle Z-E0076 RC4WD 1/10 Baja Designs S8 LED Light Bar (120mm) Z-S1093 RC4WD Billet Aluminum Fuel Cell Radio Box (Black) Z-S1122 RC4WD Billet Aluminum Fuel Cell Radio Box (Red) Z-D0034 RC4WD 70mm Old Man Emu Nitrocharger Sport Shock by ARB Z-D0038 RC4WD 90mm Old Man Emu Nitrocharger Sport Shock by ARB Z-S0342 XVD Axle for Ultimate Scale Yota TF2 Axle Z-S1590 RC4WD Warn Rock Crawler Front
100-0015