User's Manual

12
MMSI code programming

The 9-digit MMSI (Maritime Service Identity: DSC self ID) code can be programmed
at power ON.
Rotate 1. [VOL] to turn power OFF.
While pushing and holding 2. [DSC], turn power ON to enter MMSI code pro-
gramming condition.
After the display appears, release 3. [DSC], a cursor starts blinking.
Edit the specifi ed MMSI code by pushing 4. [▲] or [▼].
Push  [16] or [CH/WX] to move the cursor forward or backward, respec-
tively.
Input 9-digit code, then push 5. [DSC] to set the code.
Returns to the normal operation. 
Note:
This code programming can be performed only twice. After the code pro- 
gramming, it can be changed only by your dealer or distributor.
MMSI code check

The 9-digit MMSI (DSC self ID) code can be checked.
Push 1. [DSC] to enter the DSC menu.
Push 2. [▲] or [▼] to select “MMSI” and push [DSC].
Check the 9-digit MMSI (DSC self ID) code.3.
The MMSI code is displayed and scrolls at the channel comment indica- 
tor.
Push 4. [DSC] to return to the normal operation.
DCS address ID

A total of 30 DSC address IDs (9-digit) can be programmed and named with up to
5 characters.
Programming address ID 
Push 1. [DSC] to enter the DSC menu.
Push 2. [▲] or [▼] to select “ADDRESS”, and push [DSC].
Push 3. [▲] or [▼] to select “ADD”, and push [DSC].
DSC OPERATION