Manual

Using Coheir@!

3. Press PLAY (lhe light on |he remote starts flashing).

"II_e remote is searching lhe first set of component codes (there are 20 sets of codes). If the

component you want to operate doesn't/urn off"automalically alter 5 seconds, press PLAY

again (the light starts flashing again as the remote searches through lhe next set of codes).

Continue pressing PLAY until lhe component/urns off.

Note: If the componentdoesn'tturn off after you've pressed the PLAYbutton 20times,the

component can't beprogrammed.

4. Press REVERSE, wait 2 seconds. Repeat this step until the compone, nt turns back on.

5. To finish, press and hold lhe STOP button until the light on the remote turns oft"

Using Direct Entry

1. Turn on the component you want lhe remote to operate.

2. Look up the brand and code number(s) for the component on lhe code list on the next

page.

3. Press and hold lhe component bullon that corresponds to the component you want the

remole, to operate (VCR2 or SAT*CABLE).

4. Enter the code from the code list on the next page.

5. Release lhe component button.

6. Press ON-OFF to see if lhe component responds to the remote commands. If it doesn't, fry

pressing the component buuon and then ON* OFF again.

• If you get no response, repeat these steps using the next code listed for your brand, until

the component responds to _he remote commands.

• If you fry all the codes for your component brand and none work, try lhe automatic

code search method. If automatic code search doesn't find the code, the remote is not

compatible with your component.

How to Use the Remote After You've Programmed It

Once the remote has been programmed successfully, you are, ready to use it to control your

components. To operate the component:

1. Press the component button (VCR2 or SAT*CABLE) to set the remote to con_ol lhe

component.

2. Press ON*OFF to turn the component ON or OFF.

3. Use lhe remote buttons lhat apply to lhat component.

Notes: If you keep pressing buttons and nothing happens, the remote is probably in the wrong

mode You must press the component button that matches the component you want to operate (Le,

if you want to operate the satellite receiver, press SAT, CABLE on the remote to put it in the satellite

receiver mode).

The other remote buttons may operate differently for other components, especially when you're

using their menu systems.

Important

You must continue pressing the

component button while you

enter the code,

How to Order A New Remote Control

To order a new remote control or other accessories to use with your "lW/VCR/DVD, go to

Accessories in Chapter 6.