Manual

Playback on a TV Without Audio/Video Inputs
To connect your camcorder to a TV without audio/video inputs, you need an optional
1CVA 147C RF output adapter and an optional coaxial RF cable, such as VH82 or
VH90 shown on page 72. If your TV has audio and video inputs (or is connected to a
VCR), refer to pages 66-67.
VHF Antenna
OR
/N
n I
Optional
300-75 Ohm
Transformer
Optional Coaxial
RF Cable
(such as VH82 or VH90)
Back of TV
,€_:l--- t _
OUT TO TV Connector
\ VCRITV Switch
N
IN FROM ANT
Connector
CH3/CH4 Switch
I \
AUDIO, RF DC
OUT, VIDEO Jacks
RF Output
Adapter's Plug
t
Optional RF Output Adapter
(1CVAI47C)
Installation
l.
.
Disconnect the VHF antenna from
your TV. Connect the antenna to the
IN FROM ANT connector on the RF
output adapter if you are going to
leave the adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you need an optional 300/75 ohm
transformer.
Attach one end of the optional coaxial
RF cable to the OUT TO TV
connector on the adapter, and attach
the other end to the VHF input on
,your TV as shown.
.
Note: If your TV has 300 ohm screw
terminals, you need a 75/300 ohm
transformer,such as VH54, shown on
page 72.
Attach the RF output adapter's plug to
the AUDIO, RF DC OUT, and VIDEO
jacks located under the small cover on
the back of the camcorder.
68