Manual

J_7_|_
i ON,OFF butlon
1 W buttu'J
Find out if the remote can operate )'ourTV
This remote control is designed to operate most RCA, GE, and Proscan TVs.
L Press theTV butto_
l Press the ON'OFF button (if the TV turns on or off, this remote will operate the TV_
If tbet doesn't work. you can try programming the remote by following the
thstrucgons below.
Pro_rammin_ the remote to operate yourTV
There are _wo ways to program this remote control to operate other brands of TVs:
Direct Entry and Automatic Code Search (bo_h methods are described below).
Direct Entry
L Turn on the TV.
2. Look up the brand and code number(s) from the _ist on page 23.
3. Press and hold theTV button on the remote.
4. Keep ho_dingdown the TV button, and enter the firs_ code from the code list for your
brand (p. 23).
5. Re_easetheTV button.
6. Point the remote toward the TV and press the ON.OFF button to see if the TV turns
off. if it doesn't, press theTV button and then press ON.aPE If you get no response,
follow steps _-5 again, bu_ enter the next code from the code list for your brand of
television.
Note:Thls remote may not becompotlfilewith all brandsand modelsof t_levisions.
Automatic Code Search
The Automatic Code Search method tests all of the codes for a specific component
b_tto_. If you w_nt to stop the _utomatic code search without programming _ny of your
components, press CLEAR until the thdicator on the remote turns off.
L Turn on the TV.
2. Press and ho_d the TV button.While you condnue pressing the TV button, press _nd
hold the ON.OFF button until the thdicator light on the remote turns on-- then
release both buttons.
3. Point the remote at the TM Press and release PLAY,then wait 5 seconds or until the
indicator on the remote stops flashing.
At this point the remote is searcl_ing for the correct code to program (you'll know it's
found the correct code when the TV turns off, go to step 4). If, after 5 seconds, the TV
doesn't turn off, press PLAY again to tell the remote to search the next set of codes.
Continue pressing PLAY until the TV turns off or you have searched through all of the
codes.There are 20 tota_ sets of codes. If the component does not turn off after
pressing PLAY 20 times, then the remote c_n't be programmed to operate your brand
of TV-- you'll have to use the remote that came with your TM
4. When the TV turns off. the remote has found the proper code. Press and release
REVERSE,then wait 2 seconds. Repeat this step until theTV turns back ON.
5. To finish, press and hold STOP until the indicator on the remote turns off.
REVERSE butter, STOP button
Graphics contained within this publication are for representation only. 21