User Guide

Reference
59
AUX RF ANT IN
DIGITAL AUDIO OUTPUT
OUT
TO
TV
IN
FROM
ANT
S-VIDEO
VIDEO R LAUDIO
SATELLITE IN
PHONE JACK
CH 4
CH 3
VCR CONTROL
LOW SPEED DATA
Back Panel Controls
OUT TO TV Use to connect the receiver to your TV. However, if your
TV has audio/video jacks, you should use those jacks to get better
picture and sound quality.
IN FROM ANT Use to connect an off-air antenna or cable TV signal
to the system.
CH3/CH4 SWITCH If a coaxial cable is used to connect the receiver
to your TV, you must set the CH3/CH4 SWITCH. For example, to see
the satellite signal on TV channel 3, set the switch to 3.
S-VIDEO Provides the best picture quality. If your TV has S-VIDEO
capability, use this jack along with the audio/video jacks to connect
the receiver to your TV.
VIDEO Provides better picture quality than the OUT TO TV jack. If
your TV has audio/video capability, use this jack to connect the
receiver to your TV. You must also connect the AUDIO jacks.
AUDIO (R and L) Provide better sound quality than the OUT TO TV
jack. If your TV has audio/video capability, use these jacks to connect
the receiver to your TV. You must also connect the VIDEO jack.
Digital Audio Output Provides up to 6 independent soundtrack
channels (when available) through the optical output jack, when
connected to an optional, compatible amplifier/receiver and
speakers.
AUX RF ANT IN Use to connect an optional RF antenna for RF
remote signals. Connecting an antenna extends the remote’s range.
VCR CONTROL Allows the receiver to control your VCR.
SATELLITE IN Use to connect the receiver to the satellite dish
antenna.
LOW SPEED DATA PORT This port allows you to connect the system
to accessories, such as the Home Control base module.
PHONE JACK Use to connect a phone line to the receiver. The
system requires a phone line connection to periodically call out to
program providers.