- Thomson multimedia Inc. User's Guide Digital Media Recorder DRS7000N

10
Chapter 1: Connections and Setup
OPTICAL
COAXIAL
DIGITAL AUDIO
COMPONENT
VIDEO OUTPUT
Y
Pb
Pr
ON OFF
OUTPUTINPUT
S-VIDEO
COMPOSITE
VIDEO
AUDIO
RF ANTENNA/CABLE
INPUT
G-LINK IR SAT
L
R
L
R
PROG.
SCAN
Both Dolby Digital® and DTS® are audio formats used to record 5.1-channel audio
signals onto the digital track of film (while the film is being made). Both of these
formats provide up to six separate channels: left, right, center, left rear, right rear, and
common subwoofer. The disc will play 5.1-channel sound only if you’ve connected a
DTS or Dolby Digital receiver or decoder and if the disc is encoded in the Dolby
Digital or DTS format.
Please Read This Before Using the DIGITAL AUDIO Jacks!
This unit’s digital output jacks are designed for a connection to a Dolby Digital or
DTS receiver or decoder. Older digital equipment may not be compatible with the
Dolby Digital bitstream. Such a connection can create a high level of noise that may
be harmful to your ears, and could damage headphones or speakers. It is important
to choose the correct Digital Output setting in the
Options menu, especially when
you use either of the DIGITAL AUDIO jacks. For more information, go to page 45.
The Digital Media Recorder’s Audio Jacks
You’ll need to consult instructions that came with your audio video receiver in order
to connect it properly. The information below provides general guidelines for the
Digital Media Recorder’s Audio Output Jacks.
1. Connect the left and right audio cables to your audio/video receiver and to the
OUTPUT AUDIO L (left – white) and R (right – red) jacks on the back of your
Digital Media Recorder.
2. If you have a Dolby Digital or DTS receiver, use one of the DIGITAL AUDIO jacks
to connect the receiver to the Digital Media Recorder. You must also adjust the
Digital Output setting (go to page 45 for information).
Note: The DIGITAL AUDIO OUTPUT jack has two options: OPTICAL and COAXIAL.
Some Dolby Digital receivers have one type of Digital Audio Input jack, and some
have both. Under most conditions, optical and coaxial connections work equally well
— the only difference is the type of cable you connect to the jack.
If you want to use a less expensive cable, connect a coaxial cable to the COAXIAL
jack. Rarely, but sometimes, coaxial cables — especially long ones, pick up radio
frequency (RF) interference from household appliances, nearby power lines, and/or
broadcast towers.
If you would rather use the OPTICAL jack, connect an optical digital cable to the
Digital Media Recorder and to the corresponding digital optical input jack on the
receiver.
Note: Remove the protective cover that’s in the DIGITAL AUDIO OPTICAL jack before
connecting cables.
Consult the manual
that came with your
receiver to connect
it properly.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby
Laboratories. Confidential unpublished works. © 1992-1997 Dolby Laboratories, Inc. All rights reserved.
DTS is a registered trademark of Digital Home Theater Systems, Inc.
OUTPUT AUDIO L (left)
and R (right)
DIGITAL AUDIO
COAXIAL
DIGITAL AUDIO
OPTICAL