Quick Start Manual

EZ2120 Series RCA Small Wonder Camcorder
www.rcaaudiovideo.com
Congratulations on purchasing your new RCA Small Wonder Camcorder.
Please read these instructions for quick tips on using the product.
The User Manual PDF  le can also be found in the memory card installed in the device.
v1.0 (1.0.1.0) (EN)
QuickStartGuide
1. Content of the box
• Small Wonder Camcorder
• USB cable
• AV cable
• 4GB memory card (Installed in device)
• Software disc
• HDMI cable
• Quick Start Guide
3. General controls
SD card slot
7. Video recording and photo taking
1
2
3
4
5
Start, stop, resume recording in Video preview mode;
enter Video preview mode from other modes
Pause and resume recording
Zoom in during recording
Zoom out during recording
Switch between Video preview mode or Photo preview
mode
1
2
3
4
5
2
Actual recording time and capacity will vary depending on type of video content being recorded, system requirements,
and other factors.
You can also set video quality settings from the Setup Menu. Refer to Recording Videos section
in User Manual for more information.
Video recording indicator
8. Playing back or deleting recordings
1
2
3
5
4
1
2
3
4
5
6
7
Enter Playback mode to play the most recent recording;
start or pause playback
Adjust volume during playback
Cue to previous recording
Cue to next recording
Stop playback or enter Video preview mode from playback
mode
Press to select delete one or all recordings.
When video playback stops, enter Video preview mode
from Playback mode
6
7
6. Selecting recording quality
Memory card indicator
Battery indicator
Selected recording quality
Settings
HD
HQ
WebQ
Resolutions (pixel) &
Frame Rates (FPS)
1280 x 720 @ 30fps
720 x 480 @ 30fps
320 x 240 @ 30fps
Approx. recording durations
on a 32 GB memory card
2
Up to 16 hours
Up to 28 hours
Up to 80 hours
5. Turning on the camcorder
4. Inserting (or removing) memory card
An SD memory card is recommended for recording (memory card supplied).
English
QuickTime and the QuickTime logo are trademarks or registered trademarks of
Apple Computer, Inc., used under license therefrom.
Please charge the battery for at least four hours before  rst use.
2. Charging your camcorder
NOTE:
The unit is properly charging when you
see the animated charging symbol on the
camcorder display.
If you do not see this charging symbol, follow these
steps:
1. Make sure that you have the camcorder
connected to the computer USB port through
USB cable, and the computer is turned on.
2. Press and hold the camcorder power switch to
the ON position to initiate charging.
Lift up the cover
USB port of your
computer
USB cable
Lens
Recording
indicator
Microphone
Camcorder strap hole
On/o switch*
Delete recordings
Switch between
Photo preview
and Video preview
modes
AV output
Playback/pause
Setup menu
Record
Audio speaker
LCD screen
USB and HDMI
video output
+/– Adjust volume
during playback;
zoom during record
and preview
/ – Skip to
previous or next
recording; fast rewind
or forward
* To reset the camcorder (in case it is not functioning properly):
Press and hold the On/o switch for more than 10 seconds.
To insert card: Push the card in until a click is heard
To remove card: Push card in until a click is heard, then
slowly release the card. As card is under minimal tension
when locked in memory slot, please use care when removing.
Lift up the cover
Tripod screw hole
There are three basic modes for operating the camcorder:
Video preview mode, Photo preview mode and Playback
mode. It will always launch in video preview mode after
being switched on. Refer to the diagram below for switching
between modes.
1
In Video preview mode, press RECORD to record a video
2
In Photo preview mode, press RECORD to record a photo
Switch on
Press MODE
Press
MODE
Press
Playback mode
To end Playback mode,
simply press RECORD
which will then return
the camcorder to Video
preview mode
Video preview
mode
1
Photo preview
mode
2
Press and
hold until the
camcorder turns
on or o