Manual

Quick Guide to Your TV
Startup
5. Adjust PICTURE TILT.
Picture tilt is used to correct a tilt-
ed picture from the effect of the
Earth's magnetic field on a large
picture tube. The PICTURE TILT
STRENGTH and POLARITY
switches on the back of the TV
compensate for this effect. If the
picture appears tilted, follow these
steps to improve it.
You may need to reset the switch-
es if the TV is moved or reposi-
tioned in the room.
BACK OF TV
OFF
POLARITY
HIGH
LOW
STRENGTH
PICTURE TILT
A. Make sure STRENGTH switch
is in the OFF position.
B. Move STRENGTH switch to tile
LOW position. If this does not
fully improve tilt, move
STRENGTH switch to HIGH.
This should correct tilt. If
moving STRENGTH switch
makes tilt worse, return it to
OFF and go to the next step.
C. Change the position of
POLARITY switch. If this
improves the tilt but does not
fully improve it, move the
STRENGTH switch to LOW or
HIGH. This should .correct tilt.
6. Place all available
channels in memory
(AutoProgram)
Details for adding and deleting
Channels are on page 20.
Controls Alarm Ad
Press MENU°PROG until the
Setup menu is selected. This
menu is white.
Press MOVE • to highlight
Autoprogram.
Press MOVE b"to start placing
channels in the TV's memory.
Wait until TV has cycled
through all the channels and
returns to original channel.
7. Set the Time 12:21 AM
13
A. Press MENU'PROG until the
Alarm menu is selected. This
menu is green.
B. The Clock is automatically
highlighted the first time you
set it. if it is not, press MOVE •
(down) to highlight it.
C. Press MOVE • tO set the hour.
D, Press MOVE I_ to set the
minutes.