Manual

Connections & Setup
Plug in the TV
Plug the flat end of the cable into the power jack on the back of the "IV.
Then plug the end of the power cord into an appropriate wall outlet. Be
sure to insert the plug completely. Do not plug into an outlet controlled
by a light switch. The TV needs some power to acquire guide listings, do
recordings, etc.
Note: When you first plug your TV into an outlet the Power LED
indicator on the front panel will light for approximately 15 seconds
and then go off during the initialization of the TV.The TV can only
be turned on after the Power LED indicator goes off Thishappens
every time power isr eapplied to the TV
Put batteries in the remote
• Remove the battery compartment cover from the back of the remote
by pushing down on and sliding off the cover.
• Insert 2 "AA" fresh batteries. Make sure the polarities (+ and -) are
aligned correctly.
• Replace the cover.
Vt:R1 ON. OFF lx/
_vo VCR2 AUX _T,CA_LE
/_ L3°LL
F_T
® @
-- TVbutton
OK button
_ Arrow buttons
Use the Remote Control to Complete
the Assisted Setup
The technical term is "Navigation" - how you move through the on-
screen menus. The method is the same throughout the menu screens:
highlight your choice and select it.
To highlight a menu item, put the remote into TV mode by pressing the
"IV button then MENU. Press the arrow buttons on the remote to
highlight one of the items listed in the menu. Use the up or down arrow
button to move up or down. Use the right or left arrow button to move
right or left.
To select the item that you've highlighted, press OK.
Note: Highlighted means that the menu item stands out from
other menu items on the list (appears darker, brighter, or a
different color).
Turn on the TV
Press TV on the remote, or press POWER on the TV's front panel.
Note: Pressingthe TV button turns on the TV and puts the remote
into TV mode. _TV mode _ means that the buttons on the remote
control operate the TV_ functions.
Chapter I 19