Manual

ManualsBrandsRCA ManualsAudio EquipmentOfficial RCA rack system

PROSCAN®

Assembly Instructions for

, "E&Ti"_RED OCTO

Stand Models RB2710 / RB3110 / RB3510

The contemporary design of this stand and its

companion TV models will complement the furniture

iLnany room. The stand gives you beautiful, organized

,storage for your video and audio equipment.

Summary of content (4 pages)

PAGE 1
PROSCAN ® Assembly Instructions Stand Models RB2710 , "E&Ti"_RED OCTO for / RB3110 The contemporary design of this stand and its companion TV models will complement the furniture iLnany room. The stand gives you beautiful, organized ,storage for your video and audio equipment.
PAGE 2
Attaching and Adjusting 4. Insert the top hinge of the glass door into the top bushing. (If the bushing is resting on top of the hinge, insert the hinge and bushing into the top hole.) Insert the bottom hinge into bottom hinge bushing and hold it in place while sliding bottom of glass door into hinge. Then gently tighten bottom hinge against the glass door. 1. Hold the glass door up next to the stand to determine where the top hinge will be attached.
PAGE 3
Positioning and Securing TV on Top of Stand The TV cabinets are designed with areas on the bottom and back of the cabinet that allow for placement of the TV on the stand. Plastic dowels are used to keep your TV in place while the brackets secure the TV to the stand. Your TV model determines which brackets you will use. Two people are required for proper placement of the TV on the stand.
PAGE 4
Follow the directions PS31108 1. Attach below for model as shown at the right. (s): PS31160 the "L" bracket 2. Align the holes in the bracket (F1) with the holes in the TV and top of the stand. 3. Insert the cabinet screw (F4) into the top of the bracket (F1) and tighten. 4. Insert the truss head screw (F3) into the predrilled hole from the bottom side of the stand and tighten with the wing nut (F2).