User's Manual

Recording Mode
EN
9
Setting Recording Mode
You can select between two recording
modes - manual recording and AVR
(automatic voice recording).
1. Manual Recording
1. In STOP mode, select folder (A, B, C ,
D or ).
2. Press RECORD to start recording.
3. To pause recording, you can press
RECORD once, press again to resume
recording.
4. To stop recording, press STOP.
2. AVR (Automatic Voice
Recording)
This feature allows the unit to sense
sound and to record only when you are
speaking into the microphone. When
dictation stops for about 3 seconds,
recording will stop and then start again
automatically when you resume
dictation.
1. Select destination folder (A, B, C , D or
).
2. Press MENU four times.
3. Press REVERSE or FORWARD to
toggle between AVR on and AVR off.
4. Press STOP to exit to
STOP mode.
5. Press RECORD to
enter AVR mode.
6. During AVR on
recording, adjust the
sensitivity of the
microphone by
pressing VOL UP and
VOL DOWN, SEN
with sensitivity value
shows on display (e.g.
increase sensitivity
value when recording
source is far from the
unit or the recording
envionment is quiet.).
7. Start dictation.
Recording starts
automatically.
8. Press STOP to end AVR recording.
9. Repeat step 2 and select AVR OFF for
de-selection.
Tip:
To view the remaining time
and other recording
information, you may press
PLAY during recording.
Tip:
The first syllable or two
may be lost when you start
recording because this
‘sound’ is used to turn on the AVR
feature. It is a good practice to make
some ‘sounds’ or say a short word to
activate the AVR before you begin
actual dictation.
AVR
AVR
SP
DICT
AVR
AM
A
RP5030 EN(A ver.) 7/3/06 4:56 PM Page 14