- Thomson Inc. User's Guide TV RD900W
Table Of Contents
- Things to Consider Before You Connect
- Protect Against Power Surges
- Protect Components from Overheating
- Position Cables Properly to Avoid Audio Interference
- Connection Pictures
- Audio System Requirements
- Computer System Requirements
- Windows® PC Requirements
- Unpack the box and check your parts
- Front of the Lyra Wireless Units
- Back of the Lyra Wireless Units
- Connecting the Lyra Wireless Transmitter to your Computer
- Connecting the Lyra Wireless Receiver to your Audio Receiver
- Improving Performance
- Orientation of the Antennas
- Fine Tuning the Lyra Wireless
- If there is no signal at all
- If the signal is weak or there is interference
- Avoiding Interference
- Cordless Phone and Baby Monitor Interference
- Chapter 2: MUSICMATCH and the Lyra Wireless
- Install the software on your computer
- Launching MUSICMATCH
- Launching the Remote Control Software
- Turning off the Chime
- Closing the Remote Control Software
- Audio Setup
- Settings in MUSICMATCH
- Soundcard Settings in Your Computer’s Control Panel
- CD-ROM Settings in Your Computer’s Control Panel
- More on MUSICMATCH
- Install Batteries in the Remote
- Playing Music through the Lyra Wireless
- Fine Tuning the Lyra Wireless
- If there is no signal at all
- If the signal is weak or there is interference
- Improving Performance
- Orientation of the Antennas
- Using the Remote with MUSICMATCH
- Launching MUSICMATCH
- Music Sources
- Playing Music
- Changing Tracks and Scanning Within a Track
- Adjusting the Volume
- Changing Playlists and Internet Radio Stations
- Repeating a Playlist
- Buying Music
- Chapter 3: Additional Information
- Troubleshooting
- Care and Cleaning
- FCC and Industry Canada Information
- Limited Warranty
Chapter 1: Connections and Setup
Chapter 1 7
Connecting the Lyra Wireless Transmitter to your Computer
1. Connect the small end of the USB cable to the USB jack on the back of the Lyra Wireless
transmitter and the other end to the USB jack on your computer.
2. Connect the small end of the large power supply to the power jack on the back of the Lyra Wireless
transmitter and the other end into an AC outlet.
3. Make sure the ON switch is set to ON (the power indicator comes on).
4. Make sure the CHANNEL switch is set to the same channel as the CHANNEL switch on the Lyra
Wireless receiver.
5. Extend and position the wire antenna on the back of the unit for best possible remote control
reception.
6. Raise the antenna on the front of the unit so it is straight up.
7. Position the transmitter so that it is facing in the general direction of the receiver.
8. Follow the steps on the next page to connect the Lyra Wireless receiver to your audio receiver.
CHANNEL
USB
9V
ON OFF
1 2 3 4
POWER
POWER
1
2
3
4
5