Installation Guide

16
The waveguide cover is located on the
ceiling in the oven cavity. It is made from
mica so requires special
care. Keep the
waveguide cover clean to assure
good
oven performance. Carefully wipe with a
damp cloth any food spatters from the
surface of the cover immediately after they
occur. Built-up splashes may overheat and
cause smoke or possibly catch fire. DO
NOT REMOVE THE WAVEGUIDE
COVER.
Odor Removal
Occasionally, a cooking odor may remain
in the oven. To remove, combine 1 cup
water, grated peel and juice of 1 lemon and
several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes
using 100% power. Allow to set in oven
until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be
removed for easy cleaning. Wash them in
mild, sudsy water; for stubborn stains use
a mild cleanser and non-abrasive scouring
sponge as described above. They are also
dishwasher-proof. Use upper rack of
dishwasher. The turntable motor shaft is
not sealed, so excess water or spills
should be wiped up immediately.
Grease Filters
Filters should be cleaned at least once a
month. Never operate the fan or oven
without the filters in place.
1. Pull down slightly on the tab toward the
front of the oven and remove the filter.
Repeat for the other filter.
2. Soak the filter in a sink or dish pan filled
with hot water and detergent. DO NOT
use ammonia or other alkali; they will
react with the filter material and darken it.
3. Agitate and scrub with a brush to remove
embedded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the
opening.
Light
1. To replace light bulbs, first disconnect
power to the oven at the circuit breaker
panel or by unplugging.
2. To release cover, remove the screw on
the light cover. (See illustration.)
3. DO NOT USE A BULB LARGER THAN
30 WATTS.
4. Close light cover and secure with screw
removed in step 2.
CAUTION: Light cover may become very
hot. Do not touch glass when light is on.
Charcoal Filter
Charcoal filter is used for nonvented,
recirculated installation. The filter should
be changed every 6 to 12 months
depending on use.
1. Disconnect power to the oven at the
circuit breaker panel or by unplugging.
2. Remove the louver mounting screw from
the top center of the louver and push
down carefully on the tab at each end of
the louver to disengage it. (See
illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.